Coding agents
Coding agents
Run DeepSeek Harness, Claude Code, Codex, opencode, pi and omp on Inferam with the CLI, or configure each agent by hand.
Inferam works with the coding agents you already use. Each guide starts with the recommended way, one command with the CLI, and also covers configuring the agent by hand.
DeepSeek Harness, DeepSeek’s own harness, is the recommended one for the model Inferam serves. Inferam runs it with its session-log upload and telemetry turned off, so your sessions stay between you and us.
Pick your agent
Section titled “Pick your agent”With the CLIRecommended
Section titled “With the CLI”Once the CLI is installed and you’re signed in, prefix the agent’s own command with inferam:
inferam dshinferam claudeinferam codexinferam opencodeinferam piinferam ompEvery flag passes straight through, so the agent behaves exactly as it normally does — just on Inferam’s model.
For DeepSeek Harness, Claude Code and Codex, the setup lasts for that session only, and their config files are never changed.
In opencode, pi and omp, Inferam is added as a provider, next to the ones you already use:
inferam setup opencodeinferam setup piinferam setup ompAfter that, plain opencode, pi and omp list Inferam every time, and you can switch between it and your other providers whenever you like. inferam opencode, inferam pi and inferam omp run that setup for you the first time, then start the agent on Inferam’s model.
Using an editor instead?
Section titled “Using an editor instead?”Inferam also works inside VS Code, Cursor and Zed, both in the editor’s own chat and with coding agents in the editor. See Editors for setup and requirements.